Your basement water pump is critical to the integrity of your home. Knowing that your basement isn’t going to flood gives you peace of mind. With Eyedro’s MyEyedro cloud software you can check in on your home even when you can’t be there. Dave G. did just that and was able to use his MyEyedro data to detect the imminent failure of his water pump and correct the problem before he was forced to replace the equipment. Dave saved himself an expensive repair or replacement!
Read Dave’s story below.
“There was a regular spike every few minutes on one phase. It had to be my water pump. Sure enough I went into the cellar and it was coming on too often. I checked the plumbing for leaks. It turned out the outside tap needed a new washer. Because the connected hose was lying in the garden I would have never noticed the leak.
Thanks to your program you saved me having to buy a new water pump when it would have eventually burned out.
I have found other uses and now log in daily.”
Some Causes of Water Pump Failure:
Clogged discharge lines
Stuck or faulty switch
Lack of regular maintenance
Defective pump (fails shortly after installation)
No power – tripped breaker or outage
Eyedro saves the day!
Thanks to your program you saved me having to buy a new water pump when it would have eventually burned out.
Follow along with Kirk of the The Forever Homestead as he discusses the challenges of living off-grid in a cold climate, the need to carefully monitor power consumption vs. solar generation and how he is using the Eyedro EYEFI-4 solar energy monitor to make that an easier task!
“Monitoring power while off grid is important for many reasons including battery health. In this video we give our feedback on a device from Eyedro Green Solutions.”
Customer Experience: Energy Monitoring With the Solar-Ready EYEFI-4
By Sean McCann, Calgary, AB
Over the past few years, my family and I have been watching as the cost for our home electricity has gone up. In Alberta we pay middle-of-the-road rates for our electricity compared to the rest of Canada. Provinces like Ontario and PEI pay far higher rates. We, like other Canadian homeowners, have tried to do what we could to lower our electrical usage – we installed LED bulbs, we use home automation systems to minimize phantom power, and we have tried to limit the use of high-wattage appliances like space heaters and our electric clothes dryer.
But every month we would receive our electricity bill, and the same thought came to our minds: How are we using so much electricity?
We started researching to figure out if there was a way we could better understand our home’s energy usage and collect data that would help us find more efficiencies. When we learned about the Eyedro solar-ready energy meter and the cloud-based energy monitoring service they offered, we knew it was exactly what we were looking for.
Benefits of Energy Monitoring
We have been using the Eyedro solar energy monitoring system for about a year and a half, and the insights it provided have been very eye-opening. I loaded up the MyEyedro mobile site on my phone, and looking at the live-demand real-time data, I walked around my home turning on lights and appliances to see how they affected overall electricity consumption, and how much electricity they were using.
In our bathroom, for example, we have a vanity light with six bulbs in it. It was still using the incandescent bulbs we had inherited from the previous homeowners, and we figured we would just replace them with LED bulbs as they burnt out. When I turned on the light, the indicator on the MyEyedro app shot up by 600W – I had no idea these old bulbs were 100 watts each. That meant that for the past 8 years, when we’d had that light on for about an hour per day, those shockingly inefficient bulbs had burned through 1,752 kWh of electricity and on average that single light fixture had cost us about $158.
One light fixture, for one hour, in one room of our home, cost us a week’s worth of groceries for our family of four.
Using the MyEyedro platform, we undertook a serious audit of our electrical usage, and over the year that we have been using our Eyedro Energy Monitor, we have cut our average monthly electricity consumption somewhere between 15-20%. Understanding usage, when your home maximizes its energy consumption, and how phantom power can affect your electricity bill can lead to some significant cost savings. In our household, the Eyedro Energy Monitor has already paid for itself, and will continue to provide returns indefinitely.
Energy Monitoring with Solar-Ready EYEFI-4
Last year, we decided to take a huge step towards even more energy efficiency and invest in a home solar power system. With a capital cost of just over $5,200, it was a significant investment to make and we needed to know whether it would provide real returns. Thankfully, we had access to extremely detailed electricity usage date from the Eyedro system and the MyEyedro platform, so crunching the numbers was easy. It became clear that investing in home solar was a good decision for us, especially considering the provincial rebates available in Alberta, with similar programs available across Canada.
When our home solar system came online, we watched again as our electricity bill decreased. It was gratifying to see the investment we had made already paying dividends in the form of lower overall electricity costs.
The hardware and software that came with the solar system allowed us to see how much electricity we were generating, and the Eyedro system was able to tell us how much electricity we were consuming. But they didn’t speak to each other, and we had no way of getting any real-time or historical data on our net energy consumption.
Our solar system is a grid-tie system, which means that it feeds surplus electricity into the powerlines to be used by other customers. As such, it has to constantly monitor the electrical grid to ensure there are no disruptions; for safety reasons, it can’t be feeding electricity into power lines that are not live in case people are working on them. The system uses about 40W to do this, even overnight, which means the solar system is consuming electricity when it is dormant.
So, we still didn’t have a completely accurate picture of the overall net electricity usage of our home. The Eyedro support team was extremely helpful, and they explained that a new, second-generation Eyedro monitor had just been released, the solar-ready EYEFI-4. The EYEFI-4 is able, in real-time, to tell you how much your solar array is generating, how much electricity your home is consuming, and how much surplus you are generating.
The EYEFI-4 accounts for ALL electrical usage and calculates it into the net usage of your home. This gives you the most accurate possible data on how your home solar system is performing, and the true impact it is having on your electricity costs.
You can access this real-time data through the MyEyedro service. And because MyEyedro is cloud-based, you can access the real-time data from anywhere. I have on many occasions shown friends the MyEyedro Net Meter on my phone, and they are always impressed that I have instant access to that information even when I am not at home.
With the EYEFI-4, we now have the most complete picture possible of our energy generation and consumption, and we have the data we need to calculate the return on our investment on a daily basis.
Eyedro EYEFI-4 Solar Energy Monitor Installed in Electrical Panel
Taking it to the next level
Warning: it’s about to get super nerdy here for a bit!
As a technology enthusiast, I’ve found the Eyedro system to be cool enough on its own, but the EYEFI-4 takes it to the next level. This version of the hardware has an open API, which means you can access the real-time data from the monitor itself, and not just from the MyEyedro service. This is important because with a little bit of programming skill and some creativity, you can integrate the data from the Eyedro EYEFI-4 into your home automation systems and create rules and automations that incorporate the Eyedro data.
A lot of companies limit your access to the data you are creating by forcing you to use their platforms to access the data. Oftentimes this requires a subscription to a service; you have to pay to access your own data. Eyedro has no such restriction or subscription – the MyEyedro platform is completely free to access all the features.
The Eyedro team has even provided instructions on how to directly access the data on their blog, and even given sample code on how it could be used. This might not seem significant to a lay-user, but to a person who can use this data, it’s extremely exciting! With access to your real-time electricity data and the right programming skills, you can truly take control of your energy usage.
For example, let’s say a homeowner has a home automation system that includes an air conditioner and a temperature sensor. She has set up a rule that will turn on the air conditioner when the temperature in the room goes above 25C. If she has the Eyedro system integrated into her system, however, she can program a rule that says the air conditioner will only turn on if the temperature exceeds 25C and her solar panels are generating more than 1,000 watts of electricity.
OK, that’s a bit of an extreme example, but the point remains: with access to data from the Eyedro EYEFI-4 solar-ready energy meter, consumers can use and analyze the real-time data the way they want, and this ability alone puts the Eyedro system head and shoulders above the other energy monitoring services out there.
Controlling Cost Creep
Understanding how your home uses electricity is one of the best ways to keep monthly costs under control. Electricity costs have been steadily increasing, and there’s no reason to believe this trend will reverse anytime soon. A critical part of insulating your household against this cost creep it to have a solid understanding of how your home uses electricity and how you can make that consumption as efficient as possible. In my experience, the Eyedro system has been invaluable in keeping my utilities costs to a minimum.
Sean McCann is a communications consultant and former journalist living in Calgary, AB, with his wife, two young sons, and German Shepherd.
“The Eyedro Wireless Home Electricity Monitor is a device that lets you monitor your electricity use by the minute from a web page. There’s also a wired version of the Eyedro Home Electricity Monitor should you wish to save $60 that appears to be the same equipment and service, and they have a version more suited to businesses, but I’m reviewing the wireless flavor.
You can access the info on any device with a modern browser, and if you have an Echo you can ask Alexa what your energy usage is.”
Brick Brewery Keeps an Eye on Energy Savings with Eyedro
Discover how Brick Brewery turned electricity monitoring into a competitive advantage using Eyedro. This testimonial video is an example of an industrial project in Kitchener-Waterloo, Ontario where Brick Brewery used the Eyedro Real-Time Electricity Monitor to help verify the success of their energy saving project. Brick Brewery keeps an eye on energy savings with Eyedro and the project results are impressive.
If you have an energy saving project and would like to use Eyedro for measurement and verification then please contact us direct or an Eyedro reseller near you.