Flow Meter Installation and Product Guide
If you have any questions about using your Eyedro Flow Meter or this installation and product guide please visit eyedro.com for information, documentation, videos, and answers to frequently asked questions.
Please read all instructions prior to installing your hardware.
Each step of the instructions must be followed carefully.
Eyedro Pulse Meters are intended to interface with the following pulse meter output formats:
- Form A (KY) dry contact pulses
- 5V DC wetting value1
- Rising or falling edge detection (default is rising edge)
- Minimum pulse width is 5ms
- Maximum frequency is 100Hz
1 A higher wetting value (up to 24V) can be achieved by connecting a separate DC power supply (not provided) to input port C of the Eyedro Pulse Monitor module. The mating connector for port C is a 1.65mm (i.d) x 3.5mm (o.d) x 9mm (length) barrel plug with center pin positive.